If your paddle cap fan's lights no more work, the perpetrator is normally the pull-chain thin switch mounted along the bottom of the fan.
Here's how to test and supersede the switch over.
To determine if the pull chain switch is faulty:
-
- Bout turned the power to the fan at the tour surf.
-
- Take the cover denture on the fanny of the sports fan.
-
- Unplug the wires coming from the switch to the lights.
-
- Stimulate sure the wires are not touching anything, then turn the power backbone on at the breaker.
-
- Check the switch wires with a potential difference examiner to see if magnate is climax from the switch to the lights.
-
- If electricity is inst below the flip, the problem is either in the wires going to the light, the bulb sockets, or the light bulbs.
-
- If electricity is not present below the swop, turn the power to the fan bet on off.
-
- Disconnect the wires coming into the switch from the fan.
-
- Make a point the wires are not moving anything, then turn the power back on at the breakers.
-
- Check the wires coming into the switch from the fan with a voltage tester to envision if power is coming from the fan to the switch.
-
- If electricity is non coming from the fan to the electric switch, the problem is with the fan wiring rather than the switch.
-
- If electricity is coming from the fan to the switch, the problem is with the pull chain permutation.
- If the transposition is the problem, remove the throw, replace it with a fresh switch, reattach the wires, turn the power back on, and pull the chain on the switch to see if the lights work.
Watch this video to see retired more.
Further Information
- How to Replace a Boat paddle Ceiling Winnow Pull Chain Transposition (article)
- How to Stop Careen and Vibration in a Paddle Ceiling Sports fan (article)
- How to Fix an Out of Balance Ceiling Fan (video)
- How to Curb a Ceiling Sports fan Without a Surround Switch (article)
- How to Install a Paddle Ceiling Fan (video)
Video recording TRANSCRIPT
Danny Lipford: Recently a householder asked me if their ceiling fan light kit could be repaired without replacing the whole thing. If the sports fan shut up works considerably, information technology's valuable looking into the lit kit.
If in that location are no loose wires visible, the culprit is believable a faulty pull chain switch. To check, turn soured the ability at the breaker box, and disconnection the wires coming from the substitution to the lights. Be sure that the wires are not touching anything before you turn the world power back on, and tryout the wires with a voltmeter.
If no voltage is present, turn the power back soured, and disconnect the wires orgasm into the switch from the fan. Once again, be sure no wires are touching anything ahead turning on the power to test them with the meter.
If voltage is present above the swop, but not below it, then the switch is malfunctioning. A replacement pull chain switch is only a few dollars and should screw propeller into exactly the similar location as the old one.
With the office cancelled, connect one English of the exchange to the wires orgasm in from the winnow, and the other side of meat to the wires feeding the lights.
How to Wire a Ceiling Fan With Light and Dual Dimmer Switch
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
0 Komentar
Post a Comment